Diamond Rings and More

People who like to listen to loud music are the ones who are likely to bridge car amplifiers. By doing this the volume of the audio is increased to a great extent and also improves the clarity of the sound. More power is also provided to the speakers. Its function is similar to that of the subwoofer. The very important fact is that the connection should be done properly the first time before testing it. It is very important to know how to bridge two car audio amps since if the connection is done in the wrong way damages can be made to speakers and also the amps itself. Due to the high power the circuits can get burnt and damage it.

With the help of this discussion things can be made for aspirants who want to connect it by themselves. The things that are required for bridging amps are a set of pliers, wire strippers, wrenches, wires that are capable of handling the power of the amps along with good quality amplifiers.

The first step to be done before performing the task is to thoroughly check the manuals of both the amplifiers given by the manufacturer. Only the amplifiers which has got same characteristics like power etc can be bridged. If amplifiers with different power rating are bridged it may lead to malfunction or even damage to the amplifiers. Thus one should ensure that both these amplifiers have same power rating. In case there is any doubt of performing the task or in determining the match among the two it is better to drop the idea of bridging them both.

Next step is to stop the power supply to the amps. Power supply to the amps can be stopped easily by disconnecting the positive cable from the battery of the car. This should be done before any connections are made. To remove the cable we may take help of the wrenches and pliers. Power supply should be completely stopped till our work is completely done .

There will be a bridge switch at the rear end of each amp usually. Turn on that switch in case if it is there. Take a wire . Remove the insulation to about half inch in both the ends of the wire taken.

The insulation is then stripped for half an inch from both the ends of the wire. The wire is then connected between the two amplifiers. In one it is connected in the positive end of an amplifier and the other end is attached to the negative of the second amplifier. This is done by wrapping wire so that it surrounds the terminals. Then the knobs are screwed back to position. Generally there is colour code for the two terminals. The colours for negative and positive are black and red respectively.

The speakers and the terminals in the bridged amplifier can be connected by the wire. The positive wire is connected to the terminal which is positive and in the same way negative is connected to the negative of the speaker.

With this article the question of how to bridge two car audio amps becomes easy. Though the instructions are enough to carry out the bridging it is very important to keep in mind that if there is any uncertainty the bridging must not be done. Since this might lead to damage in the speakers and also the amplifiers.

Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.